NSX-T 2.5: Configure a Managed Host Transport Node


If we have a vCenter Server, we can automate the installation and creation of transport nodes on all the NSX-T Data Center hosts instead of configuring manually.

If the transport node is already configured, then automated transport node creation is not applicable for that node.

Follow the steps below to configure it.

1 – Select System > Fabric > Nodes > Host Transport Nodes, from the Managed By drop-down menu, select an existing vCenter Server and Select the hosts from the list and click Configure NSX.

image

2 – Select the Transport Node Profile and click save.

image

3 – Validate the Configuration State and Node Status will show Success and Up.

image

4 – Visualize the N-VDS from vCenter Server.

image

To identify TEP IP and basic connectivity test follow the steps below.

1 – System -> Fabric -> Nodes -> Host Transport Nodes -> Select the Site A’s vCenter Server -> Select the Host. Click Physical Adapters -> Look for vmk10 and click the Interface Details icon.

It will display the TEP IP configured.

image

image

2 – View the ESXi connection status by running.

# esxcli network ip connection list | grep 1235

image

3 – Login on to the esxi host and running the command below:

# esxcli network ip interface ipv4 get

image

4 – Run the following command to perform a ping test using the TEP interface:

# vmkping ++netstack=vxlan 10.10.2.202

image

Hoping you have enjoyed this post, see you next time.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s